The config is located in `~/.config/hypr/hyprland.conf`. Hyprland will automatically generate an example config for you if you don't have one. You can find an example config [here](https://github.com/hyprwm/Hyprland/blob/main/example/hyprland.conf). By removing the line `autogenerated=1` you'll remove the yellow warning. There is no "reload" keybind. The config is reloaded the moment you save it. Start a section with `name {` and end in `}` **_in separate lines!_** {{< hint type=important >}} The default config is not complete and does not list all the options / features of Hyprland. Please refer to this wiki page and the pages linked further down here for full configuration instructions. **Make sure to read the "Variables" page as well**. It covers all the toggleable / numerical options. {{< /hint >}} # Line style Every config line is a command followed by a value. ```ini COMMAND=VALUE ``` The command can be a variable, or a special keyword (described further in this page) You are **allowed to** input trailing spaces at the beginning and end. e.g.: ```ini COMMAND = VALUE ``` is valid. ## Comments Comments are started with the `#` character. If you want to escape it (put an actual `#` and not start a comment) you can use `##`. It will be turned into a single `#` that WILL be a part of your line. # Basic configuring To configure the "options" of Hyprland, animations, styling, etc. see [Variables](../Variables). # Advanced configuring Some keywords (binds, curves, execs, monitors, etc.) are not variables but define special behavior. See all of them in [Keywords](../Keywords) and the sidebar.